acoustic | Acoustic Research Speakers | Page 2 acoustic | Acoustic Research Speakers | Page 2

Acoustic research 310 ho speakers hook up, what can i do to prevent this in the future?

Acoustic Research AR 310 HO Floor Standing Maple Wood Bi-Amplification Speakers

Bi-wire means that you have the crossovers still inside the speakers. Wire the Amp to the Woofer input terminals. One amp handles the lows, one handles the highs. A tweeter is a very light, fast moving device which can react very quickly to high frequency sounds symbols, long distance dating timeline, guitar strings I decided to see what I could do while I had them in the system and here's an acoustic research 310 ho speakers hook up mod that we both found to be a significant improvement: They do seem to have good driver integration and a smooth but colored sound in my opinion.

Bi-amp After examining a picture of a I have been servicing adcom for over 20 yearsthese are not bi amp posts, but bi wire posts. This is an old friend from many years ago who I'd not spoken to in a long time, he upgraded his system after hearing mine, he was due for it anyway I suppose.

Create an account or sign in to comment

When this is done, you can now bi-wire the speakers and amp, and use different kinds of wire for the lower frequencies and the upper frequencies, depending on your ears everyone hears a little differently, thats why there are so may makers of components, and wire.

Keep the lows away from the tweter and the highs away from the woofer They also seem to lack high end extension above 12 kHz.

This means that you have no crossovers in the speakers, instead, you have an electronic crossover between the amps and the pre-amp. I'm interested in listening impressions from people who might be interested in trying this minor mod. So what do we do? He's not an audiophile and not obsessed with Audio.

Acoustic Research Home Speakers & Subwoofers | eBay

I'd call it veiled or a lack of transparency in audio speak. They have voice coils made of heavier wire and are designed for larger movements that Bass demands. The amp handles the full range of music highs-mids-lows. Put a 20 ohm 10W resistor across the HI range terminals.

I found them to sound boxy, and to have a shouty cupped hands quality, and no deep bass.

Acoustic Research AR 310 HO speakers Floorstanding Hi-Fi loudspeakers

Remember to always read and follow your owners manual. I'll just mention that these speakers are nothing like the vintage ARs they're vented after all, could anything be more un-AR? When the shorting wires are removed completely, you have now electrically separated the tweeter and woofer from each other, while maintinaing the crossovers inside the speaker for each.

He asked if we could fix them, I said probably but that I wanted to look into it first.

Vintage Acoustic Research Speakers

Bi-amp means that 2 amps are being used, one for highs, one for lows. I suggested selling them as is, but he wants to modify them. Subsequently, woofers aren't very good for high frequencies because they are slower devices. Now he's interested in substituting a better woofer.

Add Your Answer

The highs and lows are separated in the electronic crossover. This wire cannot handle much power and if you were to put bass in to a tweeter, you would burn the tweeter out almost instantly. He came to listen today and was impressed with the improvement, listened carefully, saying this is not subtle, it is a significant improvement.

In the event that your speaker has the crossover OUTSIDE the speaker box, you should check as always with the manufacturer of the speaker to see how it can be changed to suit your needs. He said I even tried an EQ and could not get low bass out of them.

Woofers are more rugged.

Shop by category

Also noticed that there is damping in the port which is usually not recommended. Why do we have crossovers? Different kinds of speaker wire produce different results.