Amp hook up without rca tv, login to the community
Rca Hook Up Amp. Run the remaining cable through the fire wall, using a rubber grommet if it seems likely the insulated wiring may encounter sharp metal.
Disconnect the negative terminal of your car's battery for safety purposes. You should only need to do this if you are using a DVD recorder instead of just a player.
Video of the Day
Once you've double-checked these things, you're ready to start. So adding a sub is not just about adding more and deeper bass; rather, a properly integrated subwoofer can improve the overall sound of the system.
So instead of using those connections, we'll use the subwoofer's speaker-level, aka "high-level," inputs. On the back of your mixer there will be to outputs that say "output". The sub will use its built-in crossover aka "low pass" filter to determine the upper limit of the frequencies produced by the subwoofer.
Discussions - Amp hook up without rca · GitBook (Legacy)
Its really simple honestly. Turn on all of your componets to your setup, and if you have all the wires hooked up correctly the music or movie whatever your playing should come out of you speakers.
If there is no grounding point available for the negative cable, you can create your own by drilling a hole in the floor, but be absolutely certain of what is on the other side.
What you are looking for, friend, is commonly called a "Knockdown," or a "Step-Down-Converter. Best thing to do is buy a Converter box.
Merge this question into Split and merge into it SAVE In RadioCar Stereos and Speakers I recently hooked up an aftermarket cd player that had no rca jacks, I tried several ways to hook em up but none of them worked.
Run speaker wire from the outputs, located on the back of the head unit, to the amp, being sure the sound wires run on the opposite side of the car from the power wires.
Stereo receivers, pre-amps, and integrated amplifiers rarely have subwoofer output jacks or offer bass-management options. Correctly installing an amplifier is not particularly easy, but it is an important part of getting a quality sound and avoiding technical mishaps.
Your TVs cable connector broke is there anyway to hook up cable to your tv using rca jacks from the cable box to the tv? If you can't use this, the composite cables yellow, white, red will also carry both video and audio. How to Install a Car Amp with Pictures - wikiHow Rca hook up amp - Install an inline fuse holder for the power line 18 inches 46 cm or fewer from the battery terminal connection.
Add Your Answer
Make sure that the power wire and aux cable are on opposite sides of the vehicle for less distortion and interference. Mine works good know, Its about a 30 min job if you know what your doing. This device pinches off existing, amplified, speaker wires coming out of your OEM deck.
If they're over watts you need a power with in line fuse to vocal amp, direct ground, RCA's from CD to amp, a remote wire from CD to amp, speaker wire from amp to speakers. You don't necessarily need a receiver with subwoofer output jacks.
You can connect the ground wire to any secure metal piece on the frame of the car that does not have paint on it. How do you hook up your power amp to your mixer?
Take your red and white audio cables and put red to red white to white, you know the deal. It has RCAs on it If this box is connected through an RF coaxial cable the thick black cable that is twisted into placeyou don't need to disconnect it.
This is called the remote wire.
Rca Hook Up Amp. How to Install a Car Amp (with Pictures) - wikiHow
It needs to connect to low amperage power source that turns on with the radio, ie, with the ignition. Items you will need. Most, but not all, subwoofers have these inputs; they get connected using speaker cables to the same speaker output jacks on your receiver or amplifier that are also hooked up to your speakers.
You do not NEED the rca jack The top picture has just the speaker cables connected to the stereo amp; the bottom picture has the speaker and subwoofer cables connected.
The subwoofer is hooked up to the receiver with a single interconnect cable. If your TV has rca input jacks for video games, etc.
1 Suggested Answer
Installing an amp can be done without the help of a professional, Views: There are some cheaper car amps which have inputs directly from the speaker leads of the radio, as well as RCAs.
This is not recommended because you take a pretty big risk of blowing both of your amps.
You would bridge the amps, it will cut into your power, but that's how you do it. You can connect the ground wire to any secure metal piece on the frame of the car that does not have paint on it.
This red power wire should be thicker than your speaker wire--typically 8-gauge works fine.